| Same or next day shipment.
Disconnect Switch as shown in the picture is not included.
3 Pole, 9 Amp, NEMA Size 00 Contactor,
1 and 3 Phase,
120, 208, 240, 277, or 480 VAC motor voltage.
Adjust control transformer primary taps to match incoming power, 120 VAC secondary.
Steel enclosure.
UL listed.
Hand-Off-Auto-Selector in door
Green LED Run Pilot Light in door
AUTO input accepts remote dry contact.
Non-reversing
Non-combination (no disconnect)
10"H x 8"W x 6"D
Shipping weight: 22 lbs.
Overload Relay Model CRP-22
Adjustable Trip Amps from 0.3 to 1.5 Amps, no heaters required.
Solid-state Microprocessor Based
Class 1 to 30 infinitely selectable via trip time setting: adjust from 0 to 30 Seconds, the time you set is the trip time at six times the set current. Example: 10 seconds will give a Class 10 trip.
Operational Temperature: -25 to +70 degrees C
Protections:
Phase current unbalance
Phase loss/phase failure
Stall Protection
Phase current unbalance: trips within 5 seconds when the phase current unbalance exceeds 50%.
Phase loss/phase failure: trips within 3 seconds when phase current is 70% unbalanced.
Stall Protection: Trips at 170% of full load amps at 3 seconds.
LED indication of faults for over current, phase failure.
Specify Motor HP and voltage when ordering.
Three Phase
Advise of motor full load amps @ 200 VAC
Advise of motor full load amps @ 230 VAC
Advise of motor full load amps @ 460 VAC
Advise of motor full load amps @ 575 VAC
Single Phase
Advise of motor full load amps @ 115 VAC
Advise of motor full load amps @ 200 VAC
Advise of motor full load amps @ 230 VAC
Options:
Door mounted Reset Pushbutton. Add $ 28.00
Add $ 202.00
Wiring for single phase motor. No Charge.
Terminal control only (No H-O-A). No charge.
|
